Fabricated Axle Housing Kit

This is a weld it yourself kit for a 9"/10" axle housing. For installation, a jig table or I-beam is needed (not included). You have the option to add on the fixture kit for an easier install process. The axle tubes come in 30" sections so you can adjust the overall width of your housing. Please note, this kit does NOT include drain/fill plugs or studs. 

There is an optional add-on fixture kit. We highly recommend this if you don't already own a fixture setup. This was designed with a 4" bolt pattern to bolt to your existing jig table or I-beam. 

We currently do not have instructions for assembling this kit. Please be sure to take your time while welding to avoid any warping. If you are not confident in your fabrication skills, please contact your local fab shop for help.

Includes:

• Axle tubes
• Full center section
• Upper and lower link mounts
• Bump stop pads
• Upper and rear truss
• Limit strap tabs 

Housing Specifications

• 4" x .250 wall DOM
• 30" long tubes (QTY 2)
• 3/8" mild steel faceplate
• 3/16" mild steel center section
• 14.625" width center section
• 1/8" mild steel truss'
• 1/8" mild steel skid plate

Link Mount Specifications

• 3/16" mild steel link mounts
• 1/8" mild steel overlays
• 3" mount width (lower)
• 2-3/4" mount width (upper)
• 3/4" bolt

Fixture Specifications - OPTIONAL - 

• 3/16" mild steel
• 4" wide bolt pattern for jig table/i-beam
• Includes 58 pieces

This kit should be installed by a competent fabricator. If you do not have the confidence to install this properly, please contact your local fab shop. If you have any questions, please email us at sales@tedesigns.com and we would be more than happy to answer any questions.